LED Indicator 5mm24

5mm24 – 24V LED Indicator Light

This is an EarthX battery accessory. The 24V LED battery accessory has a built in resistor. This makes for an
easy installation and compatibility with a 26.2-29.2V electrical system.  Details installation directions are located in
the EarthX manual but it is very simple. To install, connect red wire to a positive bus connection. Then, connect
the black wire to fault monitoring wire (also black) that is located on the EarthX battery.

Connect the positive wire (red wire) of the LED to the electrical bus (24volt positive), typically to a fuse/breaker
downstream of the master switch.  Connect the negative of the LED (black wire) to the fault monitor wire (wire
out the side of the battery) of the battery.

Specifications:

Voltage: 24V
Color: Amber
Mounting: Nut and Washer (included)
Termination style: Wire  20ga- 48? length
Built in resistor: 500 ohm, 1/2 Watt
Drill bit size: .325 or 5/16?